![]() # Resetting the tracker using Abeeway updater. You may have to do a hard reset and re-adopt it, after you reset the switch port VLANs to default 'All' in the controller. ![]() If you tag the uplink port with VLAN 20, only VLAN 20 traffic will flow. Reset the device (revert to the original config file that was flashed in the tracker and also remove Bluetooth bond): Send the downlink ff010102 on LoRaWAN port=2 The up/down-link ports should be 'All', since all traffic flows over them, not just the management VLAN.Reset the device (revert to the original config file that was flashed in the tracker): Send the downlink ff010101 on LoRaWAN port=2.Reset the device (keeping the current configuration): Send the downlink ff010100 on LoRaWAN port=2.If you wish to reset the tracker with LoRaWAN downlink, there are three options: For more information on resetting the device with downlink, visit Abeeway trackers Reference Guide: Debug commands, Section: Resetting the device. The above button sequences only reset the tracker to the configuration that was saved in the tracker. # Resetting the tracker with LoRaWAN downlink You can also use this procedure to troubleshoot and reset the tracker. If necessary, you can force a new join request for a tracker that is already joined for example to attach it to a new network. Your tracker is a LoRaWAN® OTAA device that needs to do a join request to attach the LoRaWAN® network and get a join accept from it. # Reset the tracker and re-join the LoRaWAN network The configuration of this temperature sensor, humidity or opening / closing detection is done through a PC application provided, or via a LORAWAN downlink.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |